Cat's PM-465 has simplified grade and slope control system that provides three operating menus. On-board electronics also regulate speed, steering and rotor drive, plus self-diagnostics. Milling ...

W 100i cold mill has a 39-inch cutting width and maximum cutting depth of 12 inches, and it is the largest rear-loading mill in the line. A 215-horsepower Deutz engine meet Tier 4-Interim regulations ...

Today, milling machines are recognized as an integral part of the process for achieving quality pavement performance standards. Take a look at the journey these units have taken over the last 25 years ...

Modern milling machines look much the same as they did 30 years ago. However, they now must cut superalloys, titanium, and high-tensile steels to closer tolerances and at faster rates than before. To ...

Milling machines, also known as cold planers, complete the same task today as they did 30 years ago, but they have seen several innovations over the years and are continuing to evolve. It was actually ...

It’s easy to assume that not much has changed with face mills for a while. There’s been so much attention on other milling processes over the last few years, and face mills, or shell mills, were ...

Milling machines are nice to have around for precisely drilling holes or removing unwanted material from a part. However, they can be expensive and may not get a lot of use, two reasons why a mill ...

Ball mill load monitoring and vibration analysis lie at the heart of optimising industrial grinding processes, which are pivotal in the mining and mineral processing sectors. These techniques combine ...